Here at Low Rate Automotive Locksmith we are your source for free instructions on how to program your Chevrolet keyless entry remote controland all other kinds of vehicles, both foreign and domestic. Whether you drive a car, a truck, or an SUV we have the information you need to program your remote. Low Rate Locksmith offers detailed step-by-step directions from the manufacturer of your Chevrolet car or truck, detailing how to program the key fob remote control, or programmable key for your vehicle. If you have lost a key, replaced a defective key-less entry remote, or added a new key, we have the instructions that you need to make the remote control work for your car, truck, van, or sport utility vehicle. Please select your Year from the menu below.
Here is the list of Chevrolet Cavalier Years and models this supports:
- 1996 Chevrolet Cavalier
- 1997 Chevrolet Cavalier
- 1998 Chevrolet Cavalier
- 1999 Chevrolet Cavalier
- 2000 Chevrolet Cavalier
- 2001 Chevrolet Cavalier
- 2002 Chevrolet Cavalier
- 2003 Chevrolet Cavalier
- 2004 Chevrolet Cavalier
- 2005 Chevrolet Cavalier
1996 Chevrolet Cavalier Car Key Fob and Remote Programming Instructions:
1. Access the programming connector located in the LH trunk.
2. Jump programming connector terminals.
3. System should now lock and unlock doors to indicate programming
mode has been entered.
4. Press any button on keyless remote once.
System should now lock and unlock doors indicating successful
programming of keyless remote.
5. Repeat step 4 for additional remote or other existing keyless remote.
6. Remove programming connector jumper wire to exit programming mode.
7. Test remote(s).
1997-1999 Chevrolet Cavalier Car Key Fob and Remote Programming Instructions:
1. Make sure ignition is in the OFF position.
2. Locate the Programming Connector in the trunk (driver’s side). It is a
plastic connector with two wires leading up to it. The connector is not
plugged into anything. You may have to pull back trim to access the
3. The programming connector should have two terminals. Connect both
terminals with a suitable jumper wire. Make sure the terminals remain
connected throughout the programming procedure.
4. Press the LOCK and UNLOCK buttons on the transmitter simultaneously.
In response, the Keyless Entry Module will cycle all the Door Lock Motors
at once. Your new remote has been accepted and all existing remote codes
have been erased.
5. Repeat the previous step for each additional transmitter (including any
existing transmitters). Do not remove jumper wire in between programming
6. Remove the jumper wire from the Keyless Programming Connector.
2000-2005 Chevrolet Cavalier Car Key Fob and Remote Programming Instructions:
There is no manual on board procedure to program a keyless remote for Chevrolet Cavalier 2000 – 2005. This vehicle requires special equipment be connected to the vehicle to program the remote. Please contact your dealer or local automotive locksmith.
Chevrolet introduced the all-new J-car Cavalier subcompact in April 1981 as an early 1982 model. At that time, there was no need for keyless entry remote key fob programming instructions, as the keyless entry remote key fob option was not yet available. After GM’s previous disastrous experiences with the subcompact Vega and Monza, GM sorely needed to redeem itself in the subcompact car market, and the Chevrolet Cavalier was the car that GM put their faith in to get them back on the proper track. The Chevrolet Cavalier would last a total of 24 model years, but would only span 2 generations, undergoing only one redesign in 1995. The Chevrolet Cavalier would be succeeded by the all-new Cobalt in 2005, which was also the Cavalier’s final year. Although the Chevrolet Cavalier is no longer being produced, we still continue provide the keyless entry remote key fob programming instructions.