Here at Low Rate Automotive Locksmith we are your source for free instructions on how to program your Chevrolet keyless entry remote controland all other kinds of vehicles, both foreign and domestic. Whether you drive a car, a truck, or an SUV we have the information you need to program your remote. Low Rate Locksmith offers detailed step-by-step directions from the manufacturer of your Chevrolet car or truck, detailing how to program the key fob remote control, or programmable key for your vehicle. If you have lost a key, replaced a defective key-less entry remote, or added a new key, we have the instructions that you need to make the remote control work for your car, truck, van, or sport utility vehicle. Please select your Year from the menu below.
Here is the list of Chevrolet Lumina Years and models this supports:
- 1994 Chevrolet Lumina
- 1995 Chevrolet Lumina
- 1996 Chevrolet Lumina
- 1997 Chevrolet Lumina
- 1998 Chevrolet Lumina
- 1999 Chevrolet Lumina
- 2000 Chevrolet Lumina
- 2001 Chevrolet Lumina
1994-2001 Chevrolet Lumina Car Key Fob and Remote Programming Instructions:
Note: Existing keyless remotes will be erased with this procedure.
Existing working remotes will have to reprogrammed also.
1. Locate the programming connector wire located in the RH trunk area.
You may have to pull back right side trunk trim on trunk wall to locate
the single black/white wire.
2. The programming connector wire should have one termial in the plastic
connector on end of black/white wire. Ground the terminal in the connector
to a nearby bolt or trunk latch.
Leave connector wire connected to ground through out procedure.
3. System will now lock and unlock doors automatically to indicate
programming mode has been activated.
4. Press and hold the LOCK and UNLOCK buttons on keyless remote at the
same time for 15 seconds or until the door locks lock and unlock once.
This indicates that your new keyless remote has been programmed and
all other existing remotes have been erased.
5. Repeat step 4 for to program any additonal keyless remotes including
and existing keyless remotes. Do not remove ground wire between
programming of keyless remotes.
6. Disconnect programming connector wire from ground to exit programming
7. Test keyless remote(s).