Here at Low Rate Automotive Locksmith we are your source for free instructions on how to program your Dodge keyless entry remote control and all other kinds of vehicles, both foreign and domestic. Whether you drive a car, a truck, or an SUV we have the information you need to program your remote. Low Rate Locksmith offers detailed step-by-step directions from the manufacturer of your Dodge car or truck, detailing how to program the key fob remote control, or programmable key for your vehicle. If you have lost a key, replaced a defective key-less entry remote, or added a new key, we have the instructions that you need to make the remote control work for your car, truck, van, or sport utility vehicle. Please select your Year from the menu below.
Here is the list of Dodge Ram Van Years and models this supports:
- 2000 Dodge Ram Van
2000 Dodge Ram Van Car Key Fob and Remote Programming Instructions:
The Dodge Ram Van (2000) can ONLY have 2 remotes
1. Turn ignition to OFF.
2. Locate the Data Link Connector, its a black 16 pin connecter that is
under the driver’s side dash, right where your right knee would be.
You have to look up into the dash from below to see it.
3. Ground pin 1 of the Data Link Connector by taking a wire or paper clip
and running it from pin 1 to pin 4. Pin 4 is ground so you can just short
pin 1 to 4 and it will be grounded. Grounding pin 1 tells the system you
are ready to reprogram it.
4. Close all of your doors.
5. Turn the key to ACC then back off. The power door locks will
lock/unlock. This is the signal that the system is ready for reprogramming.
6. Push a button on your key fob, doesn’t matter which button.
7. If you have 2 key fobs, then press a button on the 2nd fob within 1minute
of pressing a button on the 1st fob. Both must be programmed at the
same time. If you only have 1 fob then press a button 2 more times to signal
that you only have one.
8. The doors will lock/unlock to signal the codes were received.
9. Remove the jumper wire from the data connector.”
10. turn key off
If you have any questions or need a professional Locksmith To assist you with your Dodge Ram Van Key Fab Programming, below is a list of Low Rate Locksmith Locations.
Dodge Ram Van key fob programming service San Diego ca Dodge Ram Van key fob programming service fair oaks ca
Dodge Ram Van key fob programming service Stockton ca Dodge Ram Van key fob programming service Roseville ca
Dodge Ram Van key fob programming service Elk Grove ca Dodge Ram Van key fob programming service Rocklin ca
Dodge Ram Van key fob programming service Sacramento ca Dodge Ram Van key fob programming service Lincoln ca
Dodge Ram Van key fob programming service Carmichael ca Dodge Ram Van key fob programming service Folsom ca
Dodge Ram Van key fob programming service Citrus Heights ca Dodge Ram Van key fob programming service San Francisco ca
[uuuuuuu”10″ grid_id=”vc_gid:1526166137653-256f494d-04f3-0″ taxonomies=”4224″]
The Dodge B-Series was a full-size van marketed under the Dodge brand by the Chrysler Corporation (1971–1998) and later DaimlerChrysler (1998–2003). Starting in 1981, the B-Series was sold as the Dodge Ram Van; the passenger variant was known as the Dodge Ram Wagon and Plymouth Voyager.
Daimler Chrysler discontinued production of the Ram Van and Ram Wagon after more than 30 years of production following the 2003 model year, replacing them with the Dodge Sprinter. All Ram Vans and Wagons were built at the Pillette Road Truck Assembly plant in Windsor, Ontario, Canada, which has since been demolished.