Toyota Camry Solara Key Fob Programming by Year

Can you program a Camry Solara fob without the dealer? For most years, yes. Pick your year for the route and best next step.

Find your year

YearDIY onboard?How it programsWorking fob?Erase riskConfidenceBest next step
2000–2003YesYes - onboard relearnNo (all-keys-lost OK)PossibleMedFollow the steps below
2004–2008YesYes - onboard relearnNo (all-keys-lost OK)PossibleMedFollow the steps below

Toyota Camry Solara key types & programming facts

Published programming instructions for the Toyota Solara/Camry Solara in this range describe onboard programming for the remote keyless entry transmitter using the vehicle’s doors, ignition, and power locks. The sources provided support remote programming for 1999-2003 and 2005-2008 Solara, but they do not document transponder-chip key programming, immobilizer procedures, or smart-key systems for this model range.

Key types used on the Camry Solara:

  • remote keyless entry fob (2000-2008)
  • transponder key (2000-2008)
  • remote-head key (not confirmed by sources)
  • flip key (not confirmed by sources)
  • smart/proximity push-to-start (not applicable / not confirmed by sources)

Common fob FCC IDs: GQ43VT14T — check the back of your fob; we confirm the exact variant on site.

2000–2003 Toyota Camry Solara

Route verified — exact steps vary by trim/equipment

Route verified as onboard programming (no dealer needed). The sequences below are general route guidance — use them only if your vehicle shows the same prompts and controls. If the prompts don’t match, stop and call us.

Show the programming methods (24 steps)

1) Preparation

Programming step
1 Key removed from ignition
Programming step
2 Driver's door open, all other doors closed
Programming step
3 Driver's door unlocked
Programming step
4 Have remote(s) ready for programming
Wait / timing window
5 Steps to be performed within 40 seconds where noted

2) Initial ignition and lock/unlock cycles

Insert the key
1 Insert key into ignition without turning, then pull out
Cycle the ignition ON/OFF
2 Within 40 seconds, perform 5 lock/unlock cycles using driver's power door lock switch starting with lock
Cycle the ignition ON/OFF
3 Maintain even pace, about one cycle per second (1 cycle = 1 lock + 1 unlock)
Close the doors
4 Close then open driver's door after cycles
Cycle the ignition ON/OFF
5 Repeat another set of 5 lock/unlock cycles within 40 seconds starting with lock

3) Ignition sequence to enter programming mode

Insert the key
1 Insert key into ignition cylinder after second set of cycles
Turn ignition to ON
2 Turn ignition to ON (Do NOT Start) then back to OFF
Cycle the ignition ON/OFF
3 Repeat turning ignition to ON then back to OFF a second time
Remove the key
4 Remove key from ignition after sequences
Cycle the ignition ON/OFF
5 Power door locks should cycle within 3 seconds to indicate entry into programming mode

4) Remote programming procedure

Press LOCK + UNLOCK
1 Within 40 seconds, press lock and unlock buttons on remote simultaneously for 1 second
Press / hold a fob button
2 Immediately after, press lock button alone and hold for 2 seconds
Cycle the ignition ON/OFF
3 Door locks should cycle once within 3 seconds to indicate successful programming
Cycle the ignition ON/OFF
4 If locks do not cycle or cycle twice, repeat simultaneous then lock-only steps
Programming step
5 Repeat the simultaneous + lock-only sequence for each additional transmitter

5) Troubleshooting and additional notes

Cycle the ignition ON/OFF
1 Return to step 1 if locks do not cycle when entering programming mode
Programming step
2 Driver's door should be closed after programming completes
Programming step
3 Suggestion to try replacing key fob battery if fob not working
Programming step
4 Links provided for finding key fob battery and replacing key fob
Keys & fobs that fit the 2000–2003 Camry Solara
Toyota OEM 3-Button Remote Key Fob (FCC ID GQ43VT14T)RemoteView fob →Toyota OEM Remote Key FobRemoteView fob →

For the 2000–2003 Camry Solara: Camry Solara key replacement & all compatible fobs →

2004–2008 Toyota Camry Solara

Route verified — exact steps vary by trim/equipment

Route verified as onboard programming (no dealer needed). The sequences below are general route guidance — use them only if your vehicle shows the same prompts and controls. If the prompts don’t match, stop and call us.

Show the programming methods (20 steps)

1) Preparation

Programming step
1 Key removed from ignition before starting procedure
Programming step
2 Driver’s door open, all other doors closed
Programming step
3 Driver’s door unlocked
Wait / timing window
4 Procedure steps timed (many steps require completion within specific seconds)
Cycle the ignition ON/OFF
5 Return to step 1 if locks do not cycle when expected

2) Initial ignition-door sequence (Step 2 & Step 3)

Insert the key
1 Within 5 seconds: insert key into ignition (do NOT turn) then pull key out, repeat once
Close the doors
2 Within 40 seconds: close then open driver’s door, repeat sequence twice
Insert the key
3 Within 40 seconds: insert key into ignition (do NOT turn) then pull key out after door sequences
Programming step
4 Sequence establishes readiness for further programming steps
Programming step
5 Timing between actions is critical for success

3) Entering programming mode (Step 4 & Step 5)

Close the doors
1 Within 40 seconds: close then open driver’s door, repeat twice before inserting key
Insert the key
2 Insert key into ignition and leave it in ignition
Close the doors
3 Close driver’s door, turn ignition to ON (do NOT start) then back to OFF, remove key
Press LOCK + UNLOCK
4 Within 3 seconds, power door locks should lock then unlock automatically
Cycle the ignition ON/OFF
5 Failure of locks to cycle requires returning to step 1

4) Remote programming sequence (Step 6)

Wait / timing window
1 Perform programming steps within 40 seconds after entering programming mode
Press LOCK + UNLOCK
2 Press lock and unlock simultaneously for 1.5 seconds
Press / hold a fob button
3 Immediately after, press and hold lock button alone for 2 seconds
Cycle the ignition ON/OFF
4 Successful programming indicated by locks locking then unlocking once; two cycles means remote not accepted
Programming step
5 Repeat simultaneous/lock steps for each additional remote
Keys & fobs that fit the 2004–2008 Camry Solara
Toyota OEM Smart Key Fob (FCC ID 14AAB)Smart KeyView fob →Toyota OEM 3-Button Remote Key Fob (FCC ID GQ43VT14T)RemoteView fob →Strattec 4-Button Remote Key Fob (FCC ID GQ43VT20T)RemoteView fob →

For the 2004–2008 Camry Solara: Camry Solara key replacement & all compatible fobs →

How we validate this guide

Year coverage comes from our consolidated vehicle programming dataset. Route-level programming status is reviewed against internal route sheets and available manufacturer, security-access, and professional tool references. Exact button sequences are marked source-verified only when we have year/equipment-specific support; where a year is labeled “route verified, steps vary,” we confirm the exact fob, trim, and prompts before programming. Reviewed for route and safety by Mohammad H. Abdelhadi, ALOA-Certified Master Locksmith.

YearRoute statusExact steps
2000–2003Route verifiedGeneral guidance
2004–2008Route verifiedGeneral guidance

Common questions

Can I program a Toyota Solara remote myself?

Yes. The sources describe onboard remote programming using the vehicle’s ignition, driver door, and power locks.

Does this Solara use a smart key or push-to-start system?

Not in the cited sources. The results only document conventional remote keyless-entry transmitters for this model range.

What FCC ID is listed for a 2000 Toyota Solara remote?

GQ43VT14T is listed in one source for a 2000 Toyota Solara remote key fob.

Can you program a Camry Solara key fob without going to the dealership?

For most years, yes - the route is onboard relearn or an OBD tool, both of which a mobile locksmith handles at your location.

Does this program the remote only, or the transponder key too?

It depends on your key type. Tell us your FCC ID and we will confirm.

What if my year says professional programming required?

Those years need a programmer or security access; we bring the tool to you and program it on site.

How much does it cost?

It depends on year, key type, and whether you have a working key. Call (833) 439-8636 for a firm price before we dispatch.

Need your Camry Solara fob programmed? We come to you, 24/7.
Call (833) 439-8636Get a quote
Scroll to Top
☎  Tap to call 24/7 — (833) 439-8636