Here at Low Rate Automotive Locksmith we are your source for free instructions on how to program your Ford keyless entry remote control and all other kinds of vehicles, both foreign and domestic. Whether you drive a car, a truck, or an SUV we have the information you need to program your remote. Low Rate Locksmith offers detailed step-by-step directions from the manufacturer of your Ford car or truck, detailing how to program the key fob remote control, or programmable key for your vehicle. If you have lost a key, replaced a defective key-less entry remote, or added a new key, we have the instructions that you need to make the remote control work for your car, truck, van, or sport utility vehicle. Please select your Year from the menu below.
1991-1998 Ford Econoline Car Key Fob and Remote Programming Instructions:
1. Turn ignition to RUN or ACC.
2. Jump pins in programming connector plug for entire programming
procedure. All doors will lock then unlock to confirm programming
mode. (The plug is black with two wires: white with yellow stripe and
gray with yellow stripe. The plug comes out of a large harness which
runs under the column at the bottom edge of the dash.)
3. Press any button on first keyless remote. Doors locks will cycle to
confirm programming.
4. If programming second keyless remote press any button on it and door
locks will cycle to confirm programming.
5. Turn ignition to OFF. Door locks will cycle to indicate end of programming
mode. 6. Remove jumper wire in programming connector.
1999 Ford Econoline Car Key Fob and Remote Programming Instructions:
If you have a 1999 Econoline that was built early in the production year use these instructions
1. Turn ignition to RUN or ACC.
2. Jump pins in programming connector plug for entire programming
procedure. All doors will lock then unlock to confirm programming
mode. (The plug is black with two wires: white with yellow stripe and
gray with yellow stripe. The plug comes out of a large harness which
runs under the column at the bottom edge of the dash.)
3. Press any button on first keyless remote. Doors locks will cycle to
confirm programming.
4. If programming second keyless remote press any button on it and door
locks will cycle to confirm programming.
5. Turn ignition to OFF. Door locks will cycle to indicate end of programming
mode. 6. Remove jumper wire in programming connector.
If you have a 1999 Econoline that was built in the last part of the
production year use these instructions.
1. Turn ignition from OFF to RUN 8 times within 10 seconds, with the 8th time
ending in RUN. Door locks will cycle to confirm programming mode.
2. Within 20 seconds press any button on first keyless remote. Door locks will
cycle to confirm programming.
3. Within 20 seconds, press any button on second keyless remote. Door locks
will cycle again to confirm programming.
4. Turn ignition to OFF. Locks will again cycle to indicate end of programming
mode.
2000-2011 Ford Econoline Car Key Fob and Remote Programming Instructions:
1. Turn ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN. Door
locks will cycle to confirm programming mode.
2. Within 20 seconds press any button on first keyless remote. Door locks will cycle to confirm
programming.
3. Within 20 seconds, press any button on second keyless remote. Door locks will cycle again to
confirm programming.
4. Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.
If you have any questions or need a professional Locksmith To assist you with your Ford Econoline Key Fab Programming, below is a list of Low Rate Locksmith Locations.
Low Rate Locksmith Locations
Low Rate Locksmith provide automotive, commercial and residential locksmith services all around California.
Our Company is Locksmith Company In California, Our locksmiths will be in your site in 20-30 minutes from your call or request.